iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Did you get it out? It is pretty straight forward from what I remember.
Pay close attention to the bracket it is mounted to. Ours only had ONE screw holding it to the fire wall from the factory. Even though there were like six pre-drilled holes! This caused our wipers to over-stroke in both directions because the motor was not fully secure.
__________________
Jeff & Kelly
2008 Damon Astoria 3776 PE
No I still have not been able to get it out. On ours the entire assembly is mounted on the underside of the front shell below the windshield right above the front opening. Not much room to get at anything. Not able to get my head in far enough to see much of anything. Was hoping someone out there had already run into the same problem and could give me some insight. Thanks for your response. Gary B.
Linear Mode
