Help, no heat getting into bathroom. Tracked ductwork from furnace to under dinette. Good air flow to that point. Picked up ductwork again under shower and no crush or kink. Problem must be under floor between dinette and shower but no access points to check. Anyone have a similar problem or suggestions.
Thanks, BD
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Help, no heat getting into bathroom. Tracked ductwork from furnace to under dinette. Good air flow to that point. Picked up ductwork again under shower and no crush or kink. Problem must be under floor between dinette and shower but no access points to check. Anyone have a similar problem or suggestions.
Thanks, BD
The forced air furnaces have an air distribution box attached with a seperate ducting run from there to each outlet. You have to trace the hose run from the furnace to the outlet. Better yet go backward with the trace so you know you are following the correct duct hose. Usually they are kinked.
Thanks Harry B, traced hose to point that it goes under floor. About 4ft it then comes out under shower and all looks good to vent. Switched hoses at distribution box and have good air flow to vent under dinette so not a problem with dist. Box. Must be under floor and no access. Crushed or not connected.
Linear Mode
