Palazzo Slide Motors

[harvnlois]

Hi all,
We have been on a site in Cicada Springs RV Park in Killeen TX for 2 days and nites, and are into our third nite.
Opened the storage above the cockpit/windshield and the little slide motor controller has blinking red and green lites-1 green followed by 6 red. Per the controller label that indicates a motor short circuit in motor #1. We had no issues with the slide going out 2 days ago and have had no other indications of a problem since then.
Does anyone out there have experience with/knowledge of this? Hoping to not have to close and reopen the slide.
Thanks!

[Harry B]

I have the same code (6)and traced it back to a bad cable running under the slide that is developing a short. It only happens with the slide all the way out. If i leave the slide in by an inch instead of all the way out, I don't get the problem.
For the moment that is how I am dealing with it until I get a chance to replace the cable.

[Glenn2]

The controller is for the bed over your cockpit. Unpin the bed slides, turn your bed key to on and using the bed switch to lower the bed, see if the bed lowers evenly. If not, check the controller status lights and perform a reset.