Community Forums

rvbunz · 05-17-2014, 06:44 PM

Quote:

Originally Posted by Mwoodofd

Bob, did you get this fixed. My fridge did not cool well last weekend, and it sounds like it runs on propane most of the time. I left the coach plugged in and the fridge on since I came home from Indiana, and it was froze up on the inside of the freezer part, and some ice on the inside top of the regular fridge. I turned it off while it is parked the last week, and plan to take it out next weekend. Hopefully my fridge isn't going bad.

Mark, when I got home I plugged the coach in and switched the fridge to auto and it has been running fine ever since. I am however going back to camping world for an appointment on Monday to have the circuit board replaced. Even though it has been running, a warranty request was approved, they are also going to install a strip to screw on my wiper seal on galley slide. As far as your fridge freezing, check the outside drain and make sure the tube is pulled down and draining. My tube was bent up so it couldn't drain and the fins would get ice on them, no ice since I fixed the tube.

Mwoodofd · 05-17-2014, 07:16 PM

Thanks Bob, will check and see if the hose and drain is stopped up. Having all my towing stuff installed on Tuesday and Wednesday on Jeep and Motor Home. Debra and I are thinking about coming to the rally in September. Place looks very nice, and huge.

rvbunz · 05-17-2014, 07:26 PM

Quote:

Originally Posted by Mwoodofd

Thanks Bob, will check and see if the hose and drain is stopped up. Having all my towing stuff installed on Tuesday and Wednesday on Jeep and Motor Home. Debra and I are thinking about coming to the rally in September. Place looks very nice, and huge.

Sure hope you guys make the rally. We are going to have a great time.

wa8yxm · 05-18-2014, 04:30 AM

If you have to replace a control board.. I recommend you check with Dinosaur boards to see if they have a replacement.. Did that with my Furnace.. Result: A much much better board at less than half the price.. The OEM board was not nearly as well built and 2.5 times the cost.

Have not seen a Dino fridge board.. But suspect the same difference. MADE in the USA (Well assembled) they are.

rvbunz · 05-18-2014, 05:36 AM

Quote:

Originally Posted by wa8yxm

If you have to replace a control board.. I recommend you check with Dinosaur boards to see if they have a replacement.. Did that with my Furnace.. Result: A much much better board at less than half the price.. The OEM board was not nearly as well built and 2.5 times the cost.

Have not seen a Dino fridge board.. But suspect the same difference. MADE in the USA (Well assembled) they are.

The board is under warranty, so I would imagine they sent an OEM board.