To prime, you will cycle the key ON for 30 seconds (first position/not engaging the starter) then off.
You will repeat this until you hear the RPM of the fuel pump when only runs for about 30 seconds then shuts itself off from high RPM (pumping air) to lower RPM (pumping fuel).
At that point, you can start the engine.
Yes, a lot easier to hear if you have someone else to cycle the key and you are behind the passenger's rear wheel of engine overhead hatch listening to the pump.
__________________
Brett Wolfe
Ex: 2003 Alpine 38FDDS. Ex: 1997 Safari Sahara. Ex: 1993 Foretravel U240
|