My passenger bedroom slide has a bow on the bottom edge which is preventing the slide bulb gasket rom engaging the lip to seal this area. All Conor's of the slide engage the gasket as does the other 3 sides f the slide. The dealer was able to tighten up the front coners of the slide but the bottom edge of the slide still does not compress the bulb seal in the center bottom edge of the slide. Any suggestions?
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
I Have a renegade Verona vbh and the bow is at its apex in the center of the slide. The edges at the corner of the slide are 1/2 inch from the coach and the center of the slide is 11/4 inch from the side of the coach.
Linear Mode
