|
10-25-2017, 09:33 PM
|
#1
|
Senior Member
Join Date: Feb 2017
Posts: 475
|
HWH recalibration
Trying to figure out how to recalibrate an HWH leveling system on my 1997 Spartan chassis...
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
10-25-2017, 09:37 PM
|
#2
|
Senior Member
Join Date: Jun 2012
Location: AB
Posts: 7,587
|
I was not aware recalibration was possible.
__________________
2019 Unity LTV CB, pushed by a 2013 Honda CRV, BlueOx Baseplate, Aventa Bar & Patriot Brake
|
|
|
10-25-2017, 09:40 PM
|
#3
|
Senior Member
Join Date: Feb 2017
Posts: 475
|
You may be right... Whenever I hit the auto level it does not level properly...
|
|
|
10-25-2017, 09:59 PM
|
#4
|
Senior Member
Winnebago Owners Club Workhorse Chassis Owner
Join Date: May 2016
Location: Kamloops, BC, 60 miles from the Center of the Universe according to the Rinpoche, of the SF monks.
Posts: 7,387
|
Here's a link to adjusting the625 series. Remember to store and cycle the key off and on after adjusting the board.
RV Tech Library - How to Adjust the HWH Auto Leveling Sensor
Happy Glamping.
__________________
Happy Glamping, Norman & Elna. 2008 Winnebago Adventurer 38J, W24, dozens of small thirsty ponies. Retired after 40 years wrenching on trucks! 2010 Ford Ranger toad with bicycles or KLR 650 in the back. Easy to spot an RVer, they always walk around with a screwdriver or wrench in one hand!
|
|
|
10-26-2017, 03:53 AM
|
#5
|
Senior Member
Workhorse Chassis Owner
Join Date: Aug 2007
Posts: 849
|
My HWH 325 has similiar circuit board with lights. Didn't read whole link above but the adjuster on the frame side is also the same. Simple enough. Have adjusted it a couple of times over the years. Doesn't matter what the lights say, refrig, microwave, and bath door have to not swing and pillow height must be right on.
__________________
Jan and Rocky
Volunteers USFWS. 9,300 hrs each, 29 refuges. 04 Allegro 30DA, WH 8.1, Banks, 2012 Jeep Liberty , Brake Buddy Adv Select, 300watts Solar, "Philippians 4:11-13 KJV"
|
|
|
10-26-2017, 05:28 AM
|
#6
|
Senior Member
Join Date: Feb 2017
Posts: 475
|
Where was this box located on the frame? Normally....
|
|
|
10-26-2017, 05:30 AM
|
#7
|
Senior Member
Join Date: Feb 2017
Posts: 475
|
I have been all.around the pump but do not remember seeing it anywhere but will look again
|
|
|
10-26-2017, 05:34 AM
|
#8
|
Senior Member
Join Date: Oct 2012
Location: Foley AL
Posts: 7,138
|
Quote:
Originally Posted by Adamsta
I have been all.around the pump but do not remember seeing it anywhere but will look again
|
Sometimes they are between the frame rails in a basement cabinet .... need to look up while on your back in the cabinet.
__________________
2005 Newmar Essex 4502, 2013 Caddy SRX
1997 HR Endeavor 37, CAT, 1996 Geo Tracker
|
|
|
10-26-2017, 07:57 AM
|
#9
|
Senior Member
Commercial Member
Join Date: Jun 2005
Location: behind the steering wheel
Posts: 2,571
|
adamsta, you have a 610 system.
you also have an old style level sensor. this is a 4 inch round sensor, which most of the times, should be located between the frame rails near the middle of the coach. some mfg's place it in other places.
its adjusted like the new ones. just have the coach level and adjust it till the lights go out on the touch pad. you will need someone to tell you when the lights are out, since it does not have correspond lights on the sensor.
|
|
|
11-18-2017, 03:10 PM
|
#10
|
Senior Member
Join Date: Aug 2001
Location: North America somewhere
Posts: 30,903
|
My Winnebago had the original sensor under the drivers seat-underneath the coach. I have no idea where Coachmen put the sensor, perhaps a phone call to a Coachmen dealer will be fruitful.
__________________
2000 Winnebago Ultimate Freedom USQ40JD , ISC 8.3 Cummins 350, Spartan MM Chassis. USA IN 1SG 11B5MX,Infantry retired;Good Sam Life member,FMCA. " My fellow Americans, ask not what your country can do for you, ask what you can do for your country. John F. Kennedy
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|