The Alert Command from RV Automations checks shore power and automatically starts your generator in case of a power failure. An additional optional sensor can also check the inside temperature of your RV. You can also subscribe to text alerts so you can be notified of a loss of power.
- Monitors shore power directly from a 50/30-amp pedestal.
- 3 operating modes monitor when you are connected to shore power, dry camping, and also works in shore power mode if you don’t have a generator installed.
- 8-wire connection for full operation, or 4-wire for only monitoring shore power (no generator installed).
- Works with generators that have the following 4 wires: start wire, stop wire, run wire, and ground wire.
- Shore power is monitored on the 120V side of your transfer switch, allowing Alert Command to monitor shore power right from the source (power pedestal).
- May be installed inside your RV, generator compartment, or near your transfer switch.
- Runs parallel with any factory-installed auto generator start system, or in conjunction with any smart RV monitoring applications.
- What is required for installation: (4) 18-gauge wires for generator connection, (1) pair of 14-gauge wires to connect to battery and ground, (1) pair of 14-gauge wire to connect from the transfer switch to Alert Command, (4) screws to mount Alert Command.
- Enclosure Dimensions: 7-1/2” wide x 4-3/4” width x 1-1/2” height.
- Weight: 3 lbs.
- Includes (1) alert command unit, (2) heavy-duty screw connectors, (1) 120V inline fuse, (4) posi-taps.
- Limited 3-Year Manufacturer Warranty.
For more info or to purchase, click here -->
RV Automations Alert Command
Linear Mode
