Dear Fellow RVer's. I have been working on my Atwood Levelegs for a couple of days (on and off). I have had an intermittent issue with them since I bought my Fleetwood Bounder about two years ago. Problem moved around some but was generally a fault with one or more positions faulting the controller and flashing the dreaded green and red blinking lights.
After doing a lot of voltage and continuity testing the problem was isolated to an open through the Delphi Weather pack connectors at the leg. I have in the past crawled under and unplugged and re-plugged the connectors to clear the fault but never figured out why it was happening. When I was about to cut off the connectors and re-terminate them with a different type connector I examined them closely, testing for loose pins etc. all were well seated and tight. While I was looking closely I noticed the receptacles in the female connector only contact one side of the spade pin male ends and that the pins were centered on the side away from the receptacle contact area. I took a small screw driver and tweaked the pins to the contact side and low and behold I got good continuity thru the wires and motor and my leveling system started working fault free. Such a simple fix has eluded me for a year (until I finally got serious about trouble shooting the system). I know this system has other issues but I thought I would share this simple fix I used.