I replaced mine with a Frigidaire unit. Here's how I installed mine.
Installation:
1. I installed a separate 120v outlet controlled by a switch inside the MH so that I could easily turn the unit off when not needed without going outside to pull the plug (some units do not have an on/off switch).
2. I chose not to seal off the existing outside openings. I put a screen on the lower opening and installed 3ea. 12v fans in the upper vent to assure good air circulation. I used the 12v wiring from the old Norcold and put the fans on a thermally controlled line with a separate switch inside my MH.
3. In the back, I anchored the unit by putting 2 lag bolts through the bottom metal rails of the refrigerator into the flooring.
4. Inside, I attached (using 3m 3M Scotch 4910 VHB Tape 2 sided tape) 2 metal brackets to the top of the refrigerator and then screwed these to the wood above the refrigerator. I then trimmed around the perimeter of the fridge with black plastic L channel which I purchased from Display Products online ( Extrusions by Display Products Online). This can be purchased with the tape already attached.
__________________
Vera & Ken
1998 Holiday Rambler Imperial, RR8S Chassis
Cummins 6C8.3 mechanical engine, 325HP, 3060 Allison
Towing 2014 Ford Explorer
|