I have a 2017 Thor Polazzo, that I travel around in. I am a 73 year old female, travelling alone. The issue is that my automatic leveling system is not working and all of the lights to the left are all flashing all the time. The system worked fine before. I have been unable to use it since I parked it back in October of 2024. I have tried unplugging the wire from the control panel and plugging it back in, but nothing changes. I want to go out on a cross country trip, but am afraid I may damage something if I move it. Any suggestions would be greatly appreciated. Thank you in advance.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
when you say it's not working, are you saying the jacks won't go up or down? recently on our mh, the lights would flash and the alarm sounded. i checked my fluid level and it was low. after topping it off, all is good.
Check fluids is a good idea.
Recalibrate is good if it will go into that mode.
Could be a position sensor on the levelers - corroded, broken wire, etc.
If you are near Fort Myers, DW and I would be glad to take a look - At 75 I'm still good crawling under stuff - it's getting back up that is the hard part LOL.
__________________
2008 Phaeton 36QSH, Safe-t-Plus, Quadra Bigfoot
2017 Jeep Cherokee Trailhawk w/ flat tow wiring mod.
Blue ox, BrakeMaster + BrakeAway, diode lights and charge.
With all the lights flashing, it is telling you it wants a reset. Power it off, power it on and then hold all four arrow buttons down at the same time for about 8 seconds. You’ll be good to go from there!
With all the lights flashing, it is telling you it wants a reset. Power it off, power it on and then hold all four arrow buttons down at the same time for about 8 seconds. You’ll be good to go from there!
Do this first. You cannot do anything else until the error condition is cleared.
__________________
2018 Windsport 29M - 2015 Ford Explorer AWD with NSA Ready Brute Elite
Retired electronics tech
HELP With Leveling System
Linear Mode
