help with swivel seats

[anewtoi]

can someone help me get my swivel cables reconnected please? i disconnected both to remove for flooring job. i took a pic with my cell phone but i didnt know it would be all blurry. after reassembly, i see i probably didnt need to disconnect in the first place , but, i cant figure how the bracket that the cable and goes through attaches to the frame. i pic would be very beneficial. i have a 2001 national islander. thanks

[nightriderrv]

You see the lever that the cable pulls there is a metal bracket with a offset bend and a hold for the cable and there is a slit cut in the bracket, the offset bend will be over the black part of the cable not over the bear part of the cable. On the bottom of the black seat base the part that the chair sits on the side where that lever is there will be a slot for the bracket to fit into your going to have to loosen one side of the mounting bolts and remove the bolts on the the lever is on tile the chair and put the bracket in the slot then tighten it all back up

[anewtoi]

thanks for the reply. i see the release lever and the bracket with the slit. i just cant make out how to get the bracket to stay in the cutout after i have the cable thru the slit and in the bracket. i have the cable in the bracket and a c-clip type attachment holding onto the plastic clip.

[anewtoi]

ok, i see what im missing. the s lever on the end of the cable attaches in the hole forward of the slot for the bracket. thanks mark

[nightriderrv]

You got it now !!!! I thought you was having trouble with the bracket but yes the S end goes in the hole on the lever Make sure it works freely