Installed the new sensor and topped off reservoir tank. Hooked up my NexLink NL102P and tried to clear fault it said "The trouble code would not be successfully cleared before the malfunctions were fixed. Please fix it and try again."
I was pretty upset
that it was still bad so I shut her down and figured I had to take it in.
Hooked up my PDI back to the OBD port and did something wrong so shut it down again. Made sure everything was connected properly this time and fired it up again, all looked good and then I noticed check engine light and Low coolant fault was gone
not sure why my reader would not clear the fault but glad its gone. I did compare both sensors and both Ohmed out the same 460 ohms. Power at connector read 0 volts DC so I tried AC and had 5 VAC? I have another sensor on order to carry as a spare. I really need to get some manuals on this thing. Anyone have any sources?