|
|
06-26-2022, 10:53 AM
|
#1
|
Junior Member
Join Date: Mar 2022
Posts: 23
|
Monaco Executive no start
I have a 2006 Monaco Executive Rainer 41 foot with a Cummings 525 ISX that was running fine. I had it at home idling while I checked the refrigerant in the dash AC. I was getting tools when the engine just shut down. Now I have a no start problem.
It is throwing communication error codes J1939, J1587, J1708, SID 231, ABS and check engine light are both on, the gauges some times are erratic.
I checked the batteries, have disconnected the batteries overnight, tried several rest procedures and sill nothing. I have seen some threads that touch on the subject but they don't have enough detailed information to help me.
I know these are communication codes and involve the computers I just don't know where the computers are located. My research also has two different color wire schemes. Not sure where to go from here. Yes it has fuel and generator runs
Bill
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
06-26-2022, 11:16 AM
|
#3
|
Senior Member
Triple E Owners Club
Join Date: May 2021
Location: Eagle Territory
Posts: 121
|
|
|
|
06-26-2022, 11:20 AM
|
#4
|
Senior Member
Triple E Owners Club
Join Date: May 2021
Location: Eagle Territory
Posts: 121
|
|
|
|
06-26-2022, 12:56 PM
|
#5
|
Junior Member
Join Date: Mar 2022
Posts: 23
|
I don't seem to have a FMI or SPN code. working with reader to try and obtain these codes.
Reader is small and inexpensive, I don't know if I need a better scanner.
|
|
|
06-26-2022, 02:10 PM
|
#6
|
Senior Member
Join Date: Apr 2018
Posts: 3,441
|
Start cleaning grounds, disconnect the ecm wiring, spray with contact cleaner, all the usual stuff before taking it to a mechanic. They could start replacing parts and you'll have a huge bill with nothing to show for it.
|
|
|
06-27-2022, 02:54 PM
|
#7
|
Senior Member
Monaco Owners Club
Join Date: Jun 2014
Posts: 14,603
|
You probably need a different code reader.
When was the last time you changed fuel filters?
The last time I had a no start situation I had just changed fuel filter. I had air in the system and it took me fooooooor ever to get it to start. Ended up pulling the filters and starting from scratch before I finally got it started.
__________________
Jim J
2002 Monaco Windsor 38 PKD Cummins ISC 350 8.3L
2005 Jeep Grand Cherokee w/5.7 Hemi
|
|
|
06-27-2022, 03:58 PM
|
#8
|
Senior Member
Monaco Owners Club
Join Date: Oct 2009
Location: Tucson, AZ
Posts: 6,579
|
Are you using a heavy diesel code reader?
Does the engine crank and not fire?
Next time you crank it over try pumping the throttle pedal rapidly.
The engine ECU is bolted to the engine, passenger side down low, but I would start checking fuses in the battery compartment and rear run bay.
Did you check the rear start/run switch in the engine bay?
__________________
97 Monaco Windsor- Sold
07 Monaco Executive McKinley- Sold
04 Monaco Signature Chateau IV
|
|
|
06-29-2022, 07:26 AM
|
#9
|
Senior Member
Join Date: Apr 2011
Location: Powell River, B.C.
Posts: 31,486
|
Bill; I see you got another thread going about your A/C .
How did you resolve your no start ?
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
|
|
|
07-01-2022, 04:55 PM
|
#10
|
Junior Member
Join Date: Mar 2022
Posts: 23
|
5 days, 2 code readers, 3 service tec's, a lot of computer time and it was a 5 amp fuse in the very back fuse box. Nothing in this box was operating no LEDs were lit nothing. This fuse is on the trigger circuit for a rely that powers a lot of stuff including the ignition.
|
|
|
07-02-2022, 07:59 AM
|
#11
|
Senior Member
Monaco Owners Club
Join Date: Jun 2014
Posts: 14,603
|
Any chance you could post a picture of the offending fuse & location.
Glad you got it fixed.
Last time I had a no start situation I looked at all the fuses twice. I had been working at the back of the engine and though I may have hit the rear start switch, which I checked but no go.
Went through everything again and even tested the rear start and that fixed it. Not sure if I didn't fulling engage the rear start switch or not but always something to remember.
__________________
Jim J
2002 Monaco Windsor 38 PKD Cummins ISC 350 8.3L
2005 Jeep Grand Cherokee w/5.7 Hemi
|
|
|
07-02-2022, 10:34 AM
|
#12
|
Senior Member
Monaco Owners Club
Join Date: Oct 2009
Location: Tucson, AZ
Posts: 6,579
|
Yes, please post a picture?
__________________
97 Monaco Windsor- Sold
07 Monaco Executive McKinley- Sold
04 Monaco Signature Chateau IV
|
|
|
07-03-2022, 07:40 PM
|
#13
|
Junior Member
Join Date: Mar 2022
Posts: 23
|
Pictures of fuse
This is a picture and a diagram of the problem fuse I had that caused Engine to just stop and then a NO START condition. It is in the very back engine compartment Fuse panel. It is the one with all of the battery relays. The fuse is on Panel P-1. It was a standard 5 amp ATO fuse. I checked the wire size and components and it will handle 10 amps. So I replaced the ATO with a resettable circuit braker which is actually shown in the color picture as burgundy.
The fuse is not actually shown on the p1 board but I am pointing at it with a pen.
I hope this helps.
|
|
|
07-04-2022, 06:27 AM
|
#14
|
Senior Member
Monaco Owners Club
Join Date: Jun 2014
Posts: 14,603
|
Thanks,
Wonder what caused the 5 amp fuse to blow??? You may never know.
But with a resettable CB if there is a problem it will trip, you will loose power, and will be dead in the water until it resets. But if there is a continuing problem it would happen with a fuse to.
Might be an issue if your driving down the highway on a busy city at rush hour!!!
__________________
Jim J
2002 Monaco Windsor 38 PKD Cummins ISC 350 8.3L
2005 Jeep Grand Cherokee w/5.7 Hemi
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|