Atwood Level Legs are very prone to failures and intermittent operation. There is a power control, probably in electrical bay. There are two connectors on the board. The one with 4 pins has the signal for the emergency brake is engaged. If that signal isn’t present nothing will work. The pins for both connectors are the size of wire wrap pins. They are susceptible to corrosion. Try pulling and reinstall several times. Be careful you can break or pull a pin out.
If it is a matter of retracting the jacks. With engine running, place foot on brake pedal and change transmission selector to drive. There should be a loud alarm and all jacks will retract. If they won’t extend, try the pulling connectors solution above.
After having 4 power control boards failures at $525 each and one jack replaced, I replaced the whole system with HWH. Should have done that at first failure. Never has a front panel failure.
|