Community Forums

RUNDLC · 10-29-2016, 11:56 AM

Hey all I've had to replace my old 500456 control pad with power gear 500731, I've made the electrical changes per pg and the panel lights up but I can't seem to figure out how to get the Engage Brake light to quit flashing.

Has anyone dealt with this? Need some assistance
On the 6 pin connector, pin 1 is the parking brake connection, now this was used on the 500457 control box "which is the brake wire I have 12v with ignition on, does this get jumped to pin 6?

Helppppp no jacks

**RV Wizard** · 10-30-2016, 07:10 AM

Normally your parking brake will provide a ground for the leveling or slideout systems.

RUNDLC · 10-30-2016, 03:36 PM

Thanks RVWizard,

I kinda figured but I actually have 12 volts showing on that wire with the key on. I was hoping someone else had dealt with the same issue. Darn frustrating

RUNDLC · 10-31-2016, 04:23 PM

Talked with pg tech services, indeed pin 1 was looking for ground. I know I bypassed the safety features but being I'm an orphan owner I have NO IDEA how national would have wired this thing so for now I'm going this route. Maybe once I track down all the schematics I can go back and correct it.