Power Gear leveling jacks/slides

[AK2ND]

I just bought a 2004 Georgetown with a Power Gear DEWALD HYDRAULIC LEVELING SYSTEMS. After leveling the RV I turned the hydraulic jacks control panel switch to the off position and tried to open up my slides. When i depressed the button to push out my front slide the rear left jack would retraced and then extend when i pushed the same rocker switch in the IN position. For the Bedroom slide the switch did the same but with both rear jacks. In order to get my slides to work i had to fully retract my leveling jacks, push out both slides and then relevel. Has anyone experience this, i suspect a sticky solenoid or 2. This is the first time the hydraulics have been run since last fall

[azpete]

that may be the way the mfg set it up. read your operators manual. it will probably advise to extend the rooms first then level. lots of mfgs say that.
if not, you are probably right about the solenoid.