I am planning on removing (have someone who wants to buy it) the jackknife sofa in my 2008 Fleetwood Excursion. I have not looked to closely (since it is stored about 45 min away from me) and am curious if you can give me an idea on what I need tool wise and what I need to do to unbolt it.
I know I can figure it out, but if I can get some idea it will make it go faster and hopefully without damaging it.. Thanks in advance
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
You should have 4 bolts that lock the sofa to the floor on some kind of hold down plates. The sofa should be able to be taken apart in pieces but I can't help you with that.
When we tool the jackknife sofa out of our coach, we opened it flat and rolled it up on its front edge. Went right out the door (had the slide out for more room).
Now getting the new LaZBoy dual recliner IN was a different story...
__________________
Dave RVM#66 and Carol
1998 Pace Arrow Vision
Seeing the USA - 200 miles at a time
Looks like two heat vents through , so a #2 phillips and/or #2 square tip ,might have a hose clamp or zipstrips on vent tubes. Or it butts up to aquahot heater cores.
Thanks to all. It was fairly easy (If you have deep socket, swivel & regular socket) but then to get it out, it had to be disassembled, but again - not too bad. I hope the new owner can put it back & gets to enjoy it for a long time
Linear Mode
