Problem with old Pioneer. Trying new head next...
Quote:
Originally Posted by 2-Nickels View Post
The 20-VS-001 drives the video to the display when the signal indicator is activated or the “R” is selected (driven from the backup light circuit I suspect). When I googled the unit they don’t make it any longer but there were alternatives.
With video being present from each camera I suspect you cameras are all good. This then takes me back to the selector noted above. The MVA-4 is just an amplifier/ splitter. They use this to maintain video stability as video contains 1 volt and if you split it without an amplifier it looses frames.
You are correct. Actually the problem lies with the head unit. I was able to isolate with a separate camera and monitor and it worked perfectly. Turn signals and reverse etc. I was delaying putting in the new head unit until I confirmed function and wire hookup. I was chasing dead squirrels on. I will update once head unit in. However when I pulled out of Silverleaf I unhooked shore and retracted slides and drove back to RV site. Once there the slides didn’t work at all. No lights at either panel and HWH reset switch at front panel did nothing. I’ve never used reset switch before skim not sure what I should see except that it “work”
__________________
Philip & Liz Zurcher
2007 CC Affinity 700 custom #6737
ISX600 / CM870 serial number 97166522
|