Community Forums

panheadpaul · 09-07-2017, 07:05 AM

Quote:

Originally Posted by Flyin4Fun

This has has an upgrade... eliminating the circuit board.... No board so both switches are gone!

So please tell me--what is the upgrade so I can do this with mine. Been having the same problems. THanks

panheadpaul · 09-07-2017, 07:11 AM

my circuit board I think has problems , flush & flap closes then opens back up reset & does it again , no circuit board avail able , is there a upgrade kit for this 3010 in a 03 Monaco dynasty

panheadpaul · 09-07-2017, 07:25 AM

my circuit board I think has problems , flush & flap closes then opens back up reset & does it again , no circuit board avail able , is there a upgrade kit for this 3010 in a 03 Monaco dynasty

Flyin4Fun · 09-08-2017, 05:29 AM

I wish I could tell you! The ”upgrade” was performed by previous owner who has been unable to furnish any details / documents. All I have is a box of new (and old) parts... no paperwork of any kind. I believe it occurred in 2011.

C&SL · 02-21-2018, 05:05 PM

I know this is a old form but,
Just wondering if anybody else did this "upgrade" to remove the PC board?
(Sealand model 3010)

Roy1 · 02-22-2018, 09:44 AM

The circuit board finally went bad on my 3010 I considered rewiring it with manual switches to add water and activate the valve but figured I was better off replacing the toilet with a new sealand toilet for less then $200. The only problem I ran into was the floor plate slots were not positioned properly for the correct mounting. Rather then use a mounting kit or rotate the floor flange I drilled 2 holes and used 2 toilet studs (wood screw on one end and machine screw on other end) worked great.

vito.a · 02-23-2018, 09:40 AM

Roy, what model did you replace it with?

Roy1 · 02-24-2018, 12:35 PM

Quote:

Originally Posted by vito.a

Roy, what model did you replace it with?

Hi VITO
I used the sealand (dometic) model 320 the 310 would be ok but for another $20 or so the 320 was a better choice for me. If you go this route don’t try to twist the floor mounting flange and open a can of worms get the dometic mounting kit or just drill 2 holes thru the existing flange and use toilet mounting studs available at Home Depot or most hardware stores. If I remember correctly they were 6” apart on center to match the holes in the toilet flange.