I have 3 slides I need to replace the long flat seal on the underside of 2 of the slide
I also need to adjust the rollers just slightly. Any suggestions on where to get the flat rubber to make a new seal. Has anyone had a bedroom slide that the bottom slides out completely but the top does not extend? When half way out I can rock the top of the slide back and forth. I think I need to rebuild the support and rebrace the box
Thoughts ideas
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Has anyone adjusted their slide rollers what do you gage for the adjustment. I am slightly scraping the floor on one side was going to adjust up very slowly till it stopped dragging
__________________
2009 Gulfstream Caribean
40 ft trio
350 Cummins
Has anyone adjusted their slide rollers what do you gage for the adjustment. I am slightly scraping the floor on one side was going to adjust up very slowly till it stopped dragging
My slides have an adjusting nut at the outboard arm where it connects to the slide underneath. Loosen the jam nuts and make 1/4 nut turns checking the slide by running it in and out so you don't go to high.