I have a 2007 Southwind and the slide on the drivers side retracts OK at the front but is still out about 3/4 of and inch at the back. What is the best way to fix this problem? To me it looks like I have to put the slide out then unhooked the drive gears the wind in the side that's out to match them? right or wrong?
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Mine got out of whack also. Because I could not disengage the drive easily, I simply fully extended the slide, then used a jack and a length of 4x4 to gently raise one end and push it in 1/2 inch over the sprocket. I then lowered it back down and all was right with the world. Might not have been the textbook way but it worked.
Thanks for the info I thought I was on the right track but always nice to have some conformation. Took about 15 min. this morning to set it up. Looks right now when closed.
Linear Mode
