Splendide combo unit

[LSepulveda]

Won't dry solutions

[plasma800]

Define.

Won't get hot? Won't turn on? Model? All in one? Split unit?

[ctpres]

Clean cycle for 2100xc vented - remove lint from drum by hand between cycles
Page 1 of 1
Obtained from Splendide’s Technical operation, Westland Sales in
Oregon 800-356- 0766 (#5), or 503-656- 2280 (#5) technician San Saechao
PROCEDURE FOR CLEARING LINT
FROM MACHINE’S INTERIOR DUCT
1. Run*the unit without clothes and with the dry time off on cycle # 11.
2. When the water stops entering the unit push and hold the start
button until all the lights come on then release the button.
3. Next, move the cycle knob to cycle # 2 and press the start button
once (do not hold).
4. Let it run through that complete cycle.*
5. Do this twice.
If in frequent use, do this once each month to avoid buildup.
If the above treatment fails, try it again, adding a cup of white
vinegar to break down the deposited soap and fabric softener.
FALL BACK PROCEDURE
IF THE ABOVE PROCEDURE FAILS
1. Pull the unit out and remove flexible exhaust duct.
2. Pick out as much lint as you can from the air outlet on the back of
the dryer.
3. Put a garden hose in the outlet and blow the blockage into the
washer.
4. Run the washer on a short cycle. The blockage breaks up and
goes out the drain.

[MSHappyCampers]

When we bought the MH in 2012 the Splendide WD802 would not dry. It turned out that the flexible hose from the drum to the back of the unit was totally clogged with old, wet lint. Obviously someone had been running it for a long time without cleaning the lint filter.