Not sure where to ask this question but need help.
I have a 2004 Damon Intruder on a WorkHorse chassis. My windshield wipers will work only in the high speed position. When I turn the control to any other position, they stop immediately. I ordered another workhorse wiper control module but the same thing. If I unplug the module, the wipers still work the same, high speed only and will stop immediately at any other speed position.
Anyone else ever have this problem?
Thanks in advance.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
It could be the connector at the wiper's motor end. They are usually 5 wires in that connector, and two of them (coming from the high and low power relay of the module) are necessary to regulate the motor speed. Check the wires and blades to make sure they are functional.
__________________ 1999 GBM CruiseMaster
Toad: 2017 Toyota Corolla SE
You know the control is not the problem source. Bench-test the motor.
2000 Winnebago Ultimate Freedom USQ40JD, ISC 8.3 Cummins 350, Spartan MM Chassis. USA IN 1SG 11B5MX,Infantry retired;Good Sam Life member,FMCA." My fellow Americans, ask not what your country can do for you, ask what you can do for your country. John F. Kennedy