Both front and rear left turn lamps flash and dash camera switches to ‘left view’ as expected with turn signal lever in ‘left turn’ position.
Only rear right turn lamps flash with turn signal lever in ‘right turn’ position.
Front right lamps doesn’t flash (bulb good but replaced anyway) AND dash cam does not activate. No voltage at front right turn lamp socket.
All 12VDC breakers (yes breakers, not fuses) not tripped.
1) Is there a separate fuse bank or breaker panel for right turn front only?(guessing not)
2) A relay somewhere controlling only R/F turn lamp? (guessing not)
I recently adjusted R/F mirror which houses a turn indicator LED which by the way does not illuminate now either! Could that have caused a disconnect that would make R/F turn lamp and R/Turn camera activation inoperable?
Again, R/Rear turn lamp flashes normally.
R/Front turn lamp, front mirror turn lamp inoperable and dash cam does not respond to ‘Right turn signal lever activation.
Everything on left turn lamps and dash cam response normal.
My multi meter and I have decades of successful trouble shooting but…..
This one has me stumped for sure.
Any help greatly appreciated!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Right front signal ( dash indicator , side marker , camera activation , mirror mounted light ) are all on one output from the signal switch ; separate from the rear signal .
Have you checked the signal switch outputs?
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
Problem is now intermittent. R/front only x4 endpoints previously mentioned. Stumbled across a blog detailing similar symptoms and the owner discovered “lifting up on the turn signal lever a bit” cleared the problem…albeit intermittently. I think you are on to something. I suspect switch output to r/front or perhaps the switch itself. Thanks again sir.
Linear Mode
