Adjusting electric shades

[GreggBuda]

I had a malfunction on one of my bedroom electric day shades as it rolled up too far and got stuck. I was told to take the valance off to “unstick” it and I was successful! However, I hit one of the micro switches and now it’s out of sync and rolls too far down and actually unspools to the other side of the roller! How do I reset the stop points using those 2 micro switches?

Thanks!

Gregg

[Rollin101]

Originally Posted by GreggBuda

I had a malfunction on one of my bedroom electric day shades as it rolled up too far and got stuck. I was told to take the valance off to “unstick” it and I was successful! However, I hit one of the micro switches and now it’s out of sync and rolls too far down and actually unspools to the other side of the roller! How do I reset the stop points using those 2 micro switches?

Thanks!

Gregg

That was me with removing valance.
As far as adjusting shades: hold the down micro switch while someone holds the down arrow on Vega touch. The shade will go down a few inches stop and beep. Release the Vega touch and programming switch. Go to the Vega touch and run shade down to almost where you want it, then each time you tap the Vega touch it’ll go down 1/4 in or so. When it gets to where you want it hit the up on Vega touch until it gets almost up to where you want it. Once again each tap up is about 1/4 in. When it gets to where you want it go back to down on Vega touch and it will be programmed

[Rollin101]

Originally Posted by GreggBuda

I had a malfunction on one of my bedroom electric day shades as it rolled up too far and got stuck. I was told to take the valance off to “unstick” it and I was successful! However, I hit one of the micro switches and now it’s out of sync and rolls too far down and actually unspools to the other side of the roller! How do I reset the stop points using those 2 micro switches?

Thanks!

Gregg

Did you get your shade programmed?

[B-Man49]

Here you go.

[GreggBuda]

Originally Posted by Rollin101

Did you get your shade programmed?

Haven't yet but will be working on it when I have the rig up at Spartan the next couple of days! Thanks for the guidance!

Gregg