Anthem Slideout adjustment?

[Smokingem]

Hi,

On my 2020 Anthem,

while super slides sits flat even with the tiled floor when completely deployed (out), the kitchen side slide sits 3” higher than the tiled floor. Somebody on Facebook suggested the latter may not be fully extended requiring some adjustment. Do you agree?
If the adjustment is required, is that something I can do myself?

See my picture please

Thank you in advance.

Ethan

[Butte64]

Looks normal. Check if the end pieces are up against the wall to verify full extension.

[Cruzer]

The super slide is the only one that will sit flush with the floor. The other three are strictly push-pull with no vertical change.

[brobox]

This has worked for others. There are several designs like this in the "show us your mods" post. The hump does not interfere with using a chair when sitting at the desk, only when storing.

[Smokingem]

Originally Posted by Cruzer

The super slide is the only one that will sit flush with the floor. The other three are strictly push-pull with no vertical change.

Thank you. I confirmed that the wood trims touch against the wall and cannot go further out.

[Smokingem]

Originally Posted by brobox

This has worked for others. There are several designs like this in the "show us your mods" post. The hump does not interfere with using a chair when sitting at the desk, only when storing.

Perhaps opposite.
In that particular design, the hump DOES NOT interfere with the chair stored under the desk but it DOES when somebody sits on it unless the person has a super thin body or sits too far away from the desk.

Anyways, thank you for your feedback and “show us your mods” mentioning. I will check the section for inspirations.

- Ethan

[brobox]

Originally Posted by Smokingem

Perhaps opposite.
In that particular design, the hump DOES NOT interfere with the chair stored under the desk but it DOES when somebody sits on it unless the person has a super thin body or sits too far away from the desk.

Anyways, thank you for your feedback and “show us your mods” mentioning. I will check the section for inspirations.

- Ethan

Sitting at the desk in my computer room at home right now. The wheels of my desk chair are 12 inches from where the hump would be in the MH as I type this. I am 6 ft 210 lbs. I do have a pull out keyboard tray which helps and might be another idea. I just pushed the keyboard in, the wheels would be right against the hump to write, which would still be comfortable for me.

[hdgoldie]

That desk picture was our first Entegra that we customized. That chair was never intended to be used as a desk chair. It was just a place holder until we got the proper chair. We used a standard executive desk chair which was adjusted higher when in use and lowered to store under the desk (similar to the picture) when in transit. The hump did not interfere with use. It was also pretty comfortable when we had enough guests to need extra seating.