Quote:
Originally Posted by Ron MB
When I turn on the aqua hot system and turn switch for the burner it starts right up but when fluid heats up it turns off ..... the lights indicating the heat exchangers are on do not light on the status panel..... no lights ... no heat exchanger/fan.... no heat
Frustrated
|
Here is what happened to me last year. Try jumping it with a paper clip, if it works you know what is wrong. Worth a try in the cold.
After another Tech failure and a third being too busy to diagnose the problem, I spoke with Aquahot myself last week. Asked if it was possible after being previously told not by a tech, if the low thermostat cut off could be bad? CS said it was ok to jump the LT0 and the LT1, everything fired up as it should and continue to run. They shipped the replacement to Disney, took all of 10 minutes for me to replace it. It is located in the rear of the unit. Remove the Entegra carpeted panel and it unscrews by hand. Reconnect the two wires and you are good to go, only hand tighten. We are back in the cold weather and it is nice to finally have it working again.