 |
05-30-2016, 09:22 AM
|
#1
|
|
Senior Member
Entegra Owners Club
Join Date: May 2014
Location: America
Posts: 381
|
Electric side mirrors.
Left Entegra after final warranty visit and now notice neither side mirrors will adjust from drivers console control. I can move them by hand, so not bound. The only fuse I found is marked Heated Mirrors (10 amp) which is fine. Any ideas?
__________________
Jerry & Betsy, and 4 Border Collies
2014 Aspire 42DLQ
2012 JKU Rubicon
|
|
|
 |
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
|
05-30-2016, 10:47 AM
|
#2
|
|
Senior Member
Join Date: Aug 2014
Location: Las Vegas, NV
Posts: 572
|
Jerry,
I would first try to reposition (or cycle) the center switch and move the opposite mirror then try it again on the other mirror. There maybe another fuse in the area beneath the driver area.......jack
'For those who have fought for it, freedom has a flavor, the protected will never know'
Sent from my iPhone 70NAM
__________________
Jack & Evelyn
2014 Anthem DLQ
Living the Good Life
|
|
|
|
|
05-30-2016, 02:03 PM
|
#3
|
|
Senior Member
Join Date: Oct 2012
Location: Louisiana
Posts: 11,531
|
Did any of the final PDI work that was done by a tech involve any of the switches in the console beside the driver seat? I would wonder if the wiring socket on the bottom side of the switch (on the inside of the compartment) or within the compartment itself was unplugged or separated while doing another repair and simply forgotten to reconnect. If nothing was done in that area, maybe not.
Gary
__________________
Gary and Dee, Zowie and Bowie (traveling cat sibs)
2019 Cornerstone 45B, X15-605hp, Imperial, Spartan K3,
2013 Honda CR-V toad, Demco Excali-Bar II,
Demco Baseplate, Demco Toad Light system, 73 de W5FI
|
|
|
|
|
05-31-2016, 05:52 AM
|
#4
|
|
Senior Member
Entegra Owners Club
Join Date: May 2014
Location: America
Posts: 381
|
Yeah, already checked the switch connections, but thanks for the suggestion. I'll give CS a call this week.
Quote:
Originally Posted by Gary.Jones
Did any of the final PDI work that was done by a tech involve any of the switches in the console beside the driver seat? I would wonder if the wiring socket on the bottom side of the switch (on the inside of the compartment) or within the compartment itself was unplugged or separated while doing another repair and simply forgotten to reconnect. If nothing was done in that area, maybe not.
Gary
|
__________________
Jerry & Betsy, and 4 Border Collies
2014 Aspire 42DLQ
2012 JKU Rubicon
|
|
|
|
|
05-31-2016, 06:16 AM
|
#5
|
|
Senior Member
Entegra Owners Club
Join Date: Jun 2004
Location: Bayfield, Ontario
Posts: 5,470
|
Jerry,
The top fuse panel below the drivers seat is where the mirrors get their power from. Can you confirm that other items on that same fuse panel work, such as the entry step (with key on)? If the other items do not work then the problem may be with the small silver solenoid to the right of that fuse panel. If the solenoid is the problem a controlled tap with a screwdriver may get it working. Also I think key has to be ON for mirrors to work.
__________________
Don & Gerri
2014 Entegra Anthem 44B
2014 Honda CRV Touring
1300W Solar, 1200AH LiFePO4 FMCA F443497
|
|
|
|
07-16-2016, 12:53 PM
|
#6
|
|
Senior Member
Entegra Owners Club
Join Date: May 2014
Location: America
Posts: 381
|
Follow up
I finally got a chance to investigate this. I ended up pulling the ignition switched fuse panel out and found the heated mirror power wire unplugged. Plugged it back in and all good. 
__________________
Jerry & Betsy, and 4 Border Collies
2014 Aspire 42DLQ
2012 JKU Rubicon
|
|
|
|
|
03-18-2019, 08:39 PM
|
#7
|
|
Junior Member
Thor Owners Club
Join Date: Oct 2016
Location: Ocala, Florida
Posts: 7
|
Having the same issue on 2017 Aspire
We are having the same issue after leaving dealer. Where is the ignition fuse panel that was the problem. Checked the fuse in the compartment below the driver seat.
|
|
|
|
|
03-20-2019, 06:26 PM
|
#8
|
|
Senior Member
Entegra Owners Club
Join Date: Jun 2004
Location: Bayfield, Ontario
Posts: 5,470
|
Quote:
Originally Posted by Blh8761
We are having the same issue after leaving dealer. Where is the ignition fuse panel that was the problem. Checked the fuse in the compartment below the driver seat.
|
The ignition B+ fuse panel is below the drivers seat in the drivers side compartment. Check for power from the solenoid going to the fuse panel.
__________________
Don & Gerri
2014 Entegra Anthem 44B
2014 Honda CRV Touring
1300W Solar, 1200AH LiFePO4 FMCA F443497
|
|
|
|
|
03-20-2019, 07:03 PM
|
#9
|
|
Junior Member
Thor Owners Club
Join Date: Oct 2016
Location: Ocala, Florida
Posts: 7
|
Thanks for the quick reply. That was the one.
|
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Linear Mode
