Community Forums

goldcreekrd · 02-10-2025, 02:29 PM

2014 Entegra Anthem !
After excercising the coach the other day , I pulled into the RV
garage and did not hear the fan running. Its the one under the coach
in front of the drive shaft. There was a lot of heat coming from the engine compartment. Raised the hatch and the Hydraulic fluid reservoir tank
was too hot. i waited until the next day, crawled under the coach and disconnected the power harness. I connected 12 volts and the fan wont run.
Called Spartan , they have no fans ! Manufacturer out of business .They do have a whole assembly which includes the radiator, $1196.70. Not an easy task to replace.
Has anyone out there had this issue and if so ,what was your solution ?

Regards !

Captc · 02-10-2025, 04:29 PM

In the engine room we would have them rebuilt shoreside in a couple days.

Those commercial ships, tugs and ferry boats have so many pumps and motors made to spec they have to be rebuilt so there are quite a few places that do it.

Not worth doing a Harbor Freight item. Should be better than replacing your radiator.

brobox · 02-11-2025, 05:00 AM

I was thinking the same thing, a rebuild shop. In my area there are several electric motor rebuild shops. They must do well, this one has been here as long as I have which is 36 years. https://www.pumpspluscapecoral.com/

For a replacement, try Granger. Spartan does not keep up with replacement parts when they no longer use them. Granger on the other hand finds replacements for all types of industrial uses.

Jose67 · 02-11-2025, 05:31 AM

The hydraulic fluid cooler fan should be similar to a standard radiator cooling fan. Have you tried Amazon or Ebay. Usually, all you need is the outside diameter and system voltage.

Amazon sample:
https://a.co/d/35vlNhA

Good luck!

Douglee25 · 02-11-2025, 02:10 PM

Are you talking about the littler cooler in front of the axle tucked up high?

goldcreekrd · 02-11-2025, 04:36 PM

Yes

Douglee25 · 02-11-2025, 04:39 PM

There's nothing special about that fan. Measure the dimensions of the core and mount a new one up. Summit racing has a huge selection.

goldcreekrd · 02-12-2025, 05:56 AM

Thanks to everyone who replied, saved me some money!
One other question, does this fan push or pull air across the
coil ?
Some fans are reversable !
Thanks, appreciated !

Bowman1 · 02-12-2025, 06:58 AM

Quote:

Originally Posted by goldcreekrd

Thanks to everyone who replied, saved me some money!
One other question, does this fan push or pull air across the
coil ?
Some fans are reversable !
Thanks, appreciated !

Don’t know about that specific fan, but 99%, maybe 100%, of fans pull air through the coils.

goldcreekrd · 02-13-2025, 04:32 AM

FYI, the fan is a "pull fan ".
I have a new fan on order !
Thanks to everyone for your responses !
Regards !

Douglee25 · 02-13-2025, 07:21 AM

Nice!

757driver · 02-13-2025, 10:31 AM

Quote:

Originally Posted by goldcreekrd

FYI, the fan is a "pull fan ".
I have a new fan on order !
Thanks to everyone for your responses !
Regards !

Which fan did you get? I also have a 14 Anthem and would like the info for a parts list.

goldcreekrd · 02-13-2025, 12:18 PM

From Amazon:

Spal 30101516 16" Straight Blade Low Profile Fan .

15.75 inch wide x 16.3 inch high x 2.48 inch thick.

12 volts, 1610 cfm

Its a "puller" fan.

Around $110.00

I will update once I receive it, get it installed and make sure it works !

757driver · 02-13-2025, 12:41 PM

Quote:

Originally Posted by goldcreekrd

From Amazon:

Spal 30101516 16" Straight Blade Low Profile Fan .

15.75 inch wide x 16.3 inch high x 2.48 inch thick.

12 volts, 1610 cfm

Its a "puller" fan.

Around $110.00

I will update once I receive it, get it installed and make sure it works !

Thanks for the info.