Quote:
Originally Posted by KennyGolub
We have a 2019 Aspire 44W. Has anyone with the 44W floor pan removed (or at least pulled partially out) their clothes washer ?
We have a small leak somewhere (not at the hose connection) and I would like to pull it out to investigate further. It's not critical (yet) and just puddles a tiny amount of water in the drip pan underneath.
Thanks.
.
|
I’ve removed mine. Take the doors off, remove the board at bottom. Reach back turn off water and loosen/remove the water hose. Raise the washer up and pull it toward you. Put a towel down and slide washer out on it. There should be enough drain hose to pull washer all the way. There is a plastic horseshoe that the drain hose sets in. Entegra installed some of those up behind the dryer so you may have to deal with that. They also shove about two feet of the hose into the drain.
When you put the washer back fasten that plastic horseshoe over on the right side of the washer, as you look at it, a few inches above the drain and route the hose to come out on the right side and only put 4-6 inches into the drain.
It’s a little tight, but at least you don’t have to pull the dryer.