Originally Posted by Grower15
Jeanne, What is the vender & part number for the resistor/diode Show in the picture above? This should work with any 2 wire light...correct? Yours is a great solution, I just want a brighter light on the sides. The 2-diode light that Entegra is now using just isnít bright enough. Thank you
Yes, this should work with any two wire LED light. It doesn't make the light any brighter. What it does is make the marker light dimmer, which in turn makes the flasher look brighter.
The diodes are from:
We had the resistors from another project but you can also get them on Amazon. We used 470 ohm ones on this light but you can use from 300 - 600 ohm ones. The higher the ohms, the dimmer the marker light will be which makes the flasher look brighter.
There are all sorts of resistors on Amazon. Most of the kits come with a huge assortment when you only need a couple of the one you want. If I was buying some this is probably what I would order.