|
08-08-2018, 06:20 PM
|
#1
|
Senior Member
Join Date: Nov 2011
Location: Florida
Posts: 1,456
|
Sanicon turbo retrofit /disconnecting holding tanks
I bought a sanicon turbo 700 (along with a sleeved Entegra hose) and the metal mounting bracket....I thought that was a bit difficult. I however did not realize how rare ABS fittings are these days(specifically 3”) I ordered from multiple online vendors (amazon “other sellers” Home Depot and Lowe’s) I think I have enough fittings now. The next challenge is removing and reattaching the plumbing from/to the holding tank, the connection is a bit perplexing has anyone disconnected their holding tanks? Our coach is a 2015 45B.
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
08-09-2018, 04:02 PM
|
#2
|
Senior Member
Entegra Owners Club Spartan Chassis
Join Date: Aug 2017
Location: Mission, TX
Posts: 344
|
I was thinking of doing this as well.. Please document the steps you took to do this and provide photos if you can... I also have a 45B.
Thanks and good luck!
Bill
__________________
Bill & Marcia
|
|
|
08-09-2018, 07:24 PM
|
#3
|
Senior Member
Join Date: Nov 2011
Location: Florida
Posts: 1,456
|
Will do.i had to order some fittings today and run to Home Depot, the same white wet bay liner (as oem)is available from Home Depot and Lowe’s $32 for a 4x8 sheet.
|
|
|
08-29-2018, 05:48 PM
|
#4
|
Senior Member
Join Date: Nov 2011
Location: Florida
Posts: 1,456
|
After finding and fixing water damage on the passenger side we bay I have installed the sanicon turbo 700. I still need to install the 2 switches (one in the wet bay one in the half bath like my dump valves) I worked off of a 2018 plumbing diagram fairly close (I did write down the different pipe measurements) . I will wet test on or before Friday but so far all looks good.
|
|
|
08-31-2018, 08:48 AM
|
#5
|
Moderator Emeritus
Join Date: Oct 2002
Location: Sheboygan, WI
Posts: 5,642
|
I too had trouble finding the black ABS fittings at Lowes, Home Depot and my local industrial plumbing supply house. They aren't legal to use in residential because ABS can catch fire so all you seem to find are the white PVC drain fittings. However, I did find lots of ABS fittings at the Menards store. Apparently they use them in farm use fairly often.
You can adapt ABS to PVC if needed. There is a special adhesive that is used to join the two different plastics.
__________________
Mark & Leann Quasius
2016 Cornerstone 45A
2020 Jeep Gladiator Rubicon
2021 Jeep Wrangler Rubicon
|
|
|
08-31-2018, 05:06 PM
|
#6
|
Senior Member
Entegra Owners Club Spartan Chassis
Join Date: Aug 2017
Location: Mission, TX
Posts: 344
|
After reviewing the pro's and con's of standard dump vs macerator type dump i decided to go the portable route and use it when I need to. I found a used (sounds gross), but it was a factory return, I believe the fuse was left out of the control causing it to be a "Dead Unit". Purchased it tested it, and it pumps like crazy. I then picked up a 75' 3/4" HD garden hose and it is all in a tote. Also forgot to mention I setup a 20 foot 12 gauge seo cord with a fuse and alligator clips on one end that I can connect to my 12V batteries.
The pump that I am using is a Flojet 18555-000A, Portable RV Waste Pump in a case.
__________________
Bill & Marcia
|
|
|
08-31-2018, 06:36 PM
|
#7
|
Senior Member
Join Date: Nov 2011
Location: Florida
Posts: 1,456
|
One Lowe’s near me (40 min one way drive) had a fair to good selection of abs. The reas I ordered on line I have quite a bit left over. I did however make a list of pipe and fittings needed . I do need a tutorial on posting pictures(I took a few) this project would be much easier/faster now.
|
|
|
09-01-2018, 06:54 PM
|
#8
|
Senior Member
Join Date: Nov 2011
Location: Florida
Posts: 1,456
|
I tested the plumbing 24hrs no leaks. I emptied the tanks with the sanicon (still have the 3”gravity option also) it was fast. The way I plumbed the sanicon the grey tank can gravity drain .
|
|
|
09-12-2018, 05:43 PM
|
#9
|
Senior Member
Join Date: Nov 2011
Location: Florida
Posts: 1,456
|
I am on my first trip using the sanicon turbo ,it works great.the installation took a while determining fittings needed(and ordering on line) and fixing water damage(I did let Entegra know about this common but hidden problem and the easy fix) the installation was fairly quick after all fittings arrived and very clean looking. I did write a list of fittings and pipe lights needed if anyone with a 2015 or older Cornerstone wants to do this mod.
|
|
|
09-12-2018, 05:53 PM
|
#10
|
Senior Member
Entegra Owners Club
Join Date: Apr 2007
Location: SW FL
Posts: 31,720
|
Nice job Tom and a lot less cost than a new Cornerstone.
__________________
Chuck in SW FL
Digital 2021 Cornerstone "B"
A "Digital" 2019 Cornerstone "B" Traded
A "Classic" 2014 Anthem 42 RBQ---Sold
|
|
|
09-12-2018, 05:57 PM
|
#11
|
Senior Member
Join Date: Nov 2011
Location: Florida
Posts: 1,456
|
Quote:
Originally Posted by brobox
Nice job Tom and a lot less cost than a new Cornerstone.
|
Much less (also less than a turbo 500/600 etc And it came with an Entegra exclusive covered hose I was very surprised)
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|