Slide out repair question

[MRUSA14]

I think that installing too hard or too soft a shear pin could lead to problems, so it is probably best to get them from Entegra.

While you are in there to replace the shear pin I suggest putting Locktite on the motor mounting bolts and re-tightening since these have been shown to loosen with use and you don't want to have to go in there again to tighten those bolts.

[Mac99]

The larger question to me is why is the slide so bound up
that you are shearing pins at all ?
It would seem that until you figure that out, your just
putting bandaids on the problem.