|
|
02-21-2023, 12:28 PM
|
#1
|
Member
Join Date: Feb 2009
Location: Eunice, Louisiana
Posts: 99
|
Tst tpms
I have taken advice from others here and purchased the flow through TPMS from TST. I have a couple of set up questions:
1. Where did you mount the repeater and what is your power source?
On my 2019 Anthem, the chassis batteries are so close to the engine that I am concerned about excessive heat.
2. Where did you mount the display unit?
Thanks in advance for your help.
Gerard
__________________
Gerard Caswell
Eunice, LA
2019 Entegra Anthem 44W
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
02-21-2023, 12:37 PM
|
#2
|
Senior Member
Join Date: Mar 2020
Posts: 591
|
While I do not have the TST (TireMinder i10) I mounted my repeater under there PS drive tire (I'm 40ft so no tag) and zip tied the power wire up to some wire loom that went back to my chassis battery compartment and added the ring connectors to the lugs. It's worked perfectly for 15K miles.
__________________
Jeff and Kathy
2020 Entegra Reatta XL 40Q2
2021 Wrangler Sahara RViBrake3 TireMinder i10
|
|
|
02-21-2023, 12:44 PM
|
#3
|
Senior Member
Entegra Owners Club
Join Date: Jun 2004
Location: Bayfield, Ontario
Posts: 5,470
|
Quote:
Originally Posted by lavocat
I have taken advice from others here and purchased the flow through TPMS from TST. I have a couple of set up questions:
1. Where did you mount the repeater and what is your power source?
On my 2019 Anthem, the chassis batteries are so close to the engine that I am concerned about excessive heat.
2. Where did you mount the display unit?
Thanks in advance for your help.
Gerard
|
Gerald,
I mounted the repeater to the 12v rear closet light with an in-line fuse. I have the display unit mounted on the large drivers side window at the bottom front corner with the suction cup.
__________________
Don & Gerri
2014 Entegra Anthem 44B
2014 Honda CRV Touring
1300W Solar, 1200AH LiFePO4 FMCA F443497
|
|
|
02-21-2023, 12:56 PM
|
#4
|
Senior Member
Join Date: Jul 2020
Posts: 820
|
I mounted mine in the chassis battery box and wired directly to the batteries. I mounted my display on dash to left of steering wheel and right above the light switch.
__________________
2018 Phaeton 44OH
2023 Chevy Traverse Toad
Florida
|
|
|
02-21-2023, 01:01 PM
|
#5
|
Senior Member
Join Date: Oct 2017
Posts: 313
|
Repeater
2015 Aspire, mounted it in the last bay on the passger side on the back wall
|
|
|
02-21-2023, 01:27 PM
|
#6
|
Senior Member
Entegra Owners Club
Join Date: Oct 2010
Location: Lincoln, NE
Posts: 1,206
|
2014 Anthem, repeater just in front of DEF tank, which is right in front of chassis batteries. Connected to same.
Monitor is suction cupped to warning stickers on drivers side window.
Later...
Ray
__________________
Ray & Wendy
Full-time
2014 Anthem 42RBQ - 2018 Jeep Wrangler - FMCA F521969
|
|
|
02-21-2023, 01:48 PM
|
#7
|
Community Moderator
Join Date: Dec 2021
Posts: 6,000
|
1. Where did you mount the repeater and what is your power source? rear bedroom on a side stand
2. Where did you mount the display unit? driver side window
__________________
2022 Jayco Pinnacle 36SSWS / 2016 Ford F-350 6.7L diesel crew cab long bed 4x2 DRW
2022 Thor Palazzo 33.6 diesel pusher / 2021 Chevy Equinox LT AWD toad
|
|
|
02-21-2023, 01:54 PM
|
#8
|
Senior Member
Winnebago Owners Club Workhorse Chassis Owner
Join Date: Nov 2018
Posts: 2,521
|
I put my repeater in the ceiling cavity above the bathroom sink light (removed light, connected repeater to light DC feed, stuffed into the cavity with bubble wrap, reinstalled light). The bathroom of my RV is right over the rear axle and also offers a straight shot from head level towards the cab.
Mark B.
Albuquerque, NM
|
|
|
02-21-2023, 03:42 PM
|
#9
|
Senior Member
Entegra Owners Club
Join Date: Apr 2013
Location: Las Colinas, Texas
Posts: 2,040
|
Mounted my repeater in the rear closet as well, put a switch on it so I can turn it off when not driving. I usually let the monitor sit between the 2 cup holders in my rig on the flexible stand that it just sits in.
__________________
Mark & Debra Wood, Las Colinas, TX.
2013 Entegra Aspire 42RBQ
2023 Jeep Wrangler Sahara 4XE
2013 Thor Challenger 37DT - Sold
|
|
|
02-21-2023, 03:54 PM
|
#10
|
Senior Member
American Coach Owners Club Spartan Chassis
Join Date: Mar 2018
Location: Cary, Il.
Posts: 498
|
lavocat...Smart investment in your family & coach..you won't regret it! I mounted my repeater midship where my house & chassis batteries are & put alligator clips on the repeaters + & - to the house batteries. Been using the TST System for 9 years now & has performed flawlessly & just upgraded to the new 770 display for my 8 flow thru sensors.
__________________
2004 American Eagle "J"/400 ISL/Spartan MM
Luxe Ryder Trailer
2007 Honda ST1300 & 2004 Honda Rune
|
|
|
02-21-2023, 04:42 PM
|
#11
|
Member
Fleetwood Owners Club Workhorse Chassis Owner Entegra Owners Club Spartan Chassis
Join Date: Sep 2015
Location: Camarillo, Ca
Posts: 52
|
I mounted mine in the bedroom TV compartment. Picked up a 12v source. Workers great for all rear axles and trailers. Clean & dry.
No lost sensor signals ever.
__________________
2015 Entegra Anthem 42DEQ
2004 Fleetwood Southwind 36E (Replaced)
Judy & Bob
|
|
|
02-22-2023, 05:29 AM
|
#12
|
Senior Member
Join Date: Sep 2015
Posts: 1,234
|
chassis battery compartment next to the round fuse box wires directly to the batteries
|
|
|
02-22-2023, 09:27 AM
|
#13
|
Senior Member
Join Date: Oct 2012
Location: Louisiana
Posts: 11,534
|
There is an excellent chance that you don't need the repeater. On my 2015 Anthem with TireMinder, I never added the repeater.... tried it without installing the repeater and it worked just fine and never "lost" the toad tire pressures. On this Cornerstone, I bought the TST set up for the Cornerstone as I'm "thru" with the Valor system..... too little battery "life" and too much cost to replace.
Like a bone-head, I left all the sensors at home before starting this 3,000 0 4,000 mile trip.... dumb. Now I have all the time in the world to install it, and the sensors are home.
But there is a good chance that you don't need the repeater at all.... try it without installing first and see how it works. If not good, then you have a lot of suggestions !
Gary
__________________
Gary and Dee, Zowie and Bowie (traveling cat sibs)
2019 Cornerstone 45B, X15-605hp, Imperial, Spartan K3,
2013 Honda CR-V toad, Demco Excali-Bar II,
Demco Baseplate, Demco Toad Light system, 73 de W5FI
|
|
|
02-22-2023, 11:01 AM
|
#14
|
Senior Member
Join Date: May 2016
Location: Highland NY
Posts: 3,927
|
Quote:
Originally Posted by 757driver
Gerald,
I mounted the repeater to the 12v rear closet light with an in-line fuse. I have the display unit mounted on the large drivers side window at the bottom front corner with the suction cup.
|
Ditto. Mine is also mounted there:
depending on the direction of the sun, the LED display can get washed out. They offer a visor which they claim helps. I've not felt the need to get one.
__________________
Bruce, Lisa and the pups, Charlie, Opie and Rebel
2021 Cornerstone Y Azure
2018 Anthem, Victory Blue Sold, 2019 Ram Laramie 1500
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|