Upgrade of Cornerstone sewer hose / Caution - Foul Language Required!

[Bpeter2]

Originally Posted by jb4545

Bob - I have attached the link to the Drainmaster hose I used and also a link to the post with procedures to follow. It's really not that bad to do the upgrade and it took less than an hour. I tugged and pulled on the hose for about 10 minutes and was just about ready to give up cut the elbow out when it suddenly just "popped" through. Be careful not to lose your balance when it does come through the elbow or you will take the bay door out. I also had to cut off the top half of the white PVC fitting that comes through the bulkhead. On mine, the hose came in at an angle and it was in a little bit of bind before I cut the top half of the fitting off. Good luck, you will be glad you made the change!

Products | Drain Master

http://www.irv2.com/forums/f278/2014...-212565-4.html

Go to page 4 of the thread. I used the method Xtechgeek posted.

Thanks John. I appreciate the info!

[Ann n Gene]

I just bought an extension for mine, works great. JMHO 🚌🚓

[RedRaider93]

Originally Posted by RedRaider93

When I ordered my Cornerstone, I actually thought it came with the Drainmaster hose. I was disappointed to find that it didn't. As much as those Todd's cost, you'd think Entegra would go ahead and put the best hose on at the factory.

Just so people on here don't think I'm an idiot, I meant to type "as much as those rigs cost", not as much as those "Todd's" cost. I used the Swype keyboard on my phone and sometimes it has a mind of its own. It's frustrating that you can't edit or delete your own posts after the fact...