Scan Gauge 2

[drjoe]

thinking about purchasing sg2. manual on our 13 view profile seems to imply not to connect anything to the on board diag computer. any advice will be appreciated.our problem is poor MPG
thanks
Joe

[SeeTheUSA]

No problem! ScanGuage II will work fine.

[drjoe]

not sure where and how to hook it up. advice will be appreciated. thanks for the reply
Joe

[vsheetz]

Connects to an ODBII connector. Thus connector is typically located under the dash near the steering column. Not infrequently hard to find. May have a cover over it helping to make it hard to identify.

[SeeTheUSA]

From sitting in the driver's seat, facing the steering wheel . . .

Look to the left of the steering column and just under the lower part of the dash, next to the sidewall . . . the connection is in a little compartment. You'll need to open the little cover.

[LeeB]

Originally Posted by SeeTheUSA

From sitting in the driver's seat, facing the steering wheel . . .

Look to the left of the steering column and just under the lower part of the dash, next to the sidewall . . . the connection is in a little compartment. You'll need to open the little cover.

Right by the lever that you use to open the hood, the cover remains open. I love mine so far I only use the instant mileage and water temp. I have no taken the time to set up the rest of the bells and whistles...

Does anyone know if the Scan Gauge gives Transmission readings on a 2013?

[jackfish]

Originally Posted by LeeB

Does anyone know if the Scan Gauge gives Transmission readings on a 2013?

No, only engine temperature, not transmission temperature.