Free 7 Day Trial RV GPS App RV Trip Planner Campground Reviews RV Maintenance Free 7 Day Trial ×
RV Trip Planning Discussions

Go Back   iRV2 Forums > THE CHASSIS CLUB FORUMS > Sprinter Chassis Forum
Click Here to Login
Join iRV2 Today

Mission Statement: Supporting thoughtful exchange of knowledge, values and experience among RV enthusiasts.
Reply
  This discussion is proudly sponsored by:
Please support our sponsors and let them know you heard about their products on iRV2
 
Thread Tools Search this Thread Display Modes
 
Old 09-17-2017, 10:49 AM   #1
Junior Member
 
AK VIEW's Avatar
 
Join Date: Sep 2013
Location: ALASKA - Summer / ARIZONA - Winter
Posts: 12
Cool UltraGauge OBS II

Has anyone installed this scanner. I'm interested in the size of the access to the OBD plug-in location for a 2012 Winnebago VIEW 24M. Not much room, if you want to put the cover back. The OBD location I found is inside a cover just above the hood release lever. Could there be another plug-in hidden in the engine compartment. I want to be able to get the system codes and monitor temps etc. had a "engine check" light come on, with no apparent effect on performance. It went out after an overnite shutdown and 70 miles. Heading to a "rare" Sprinter repair station tomorrow, in hope of finding any issues before heading down the Alaska hwy to the lower 48.
AK VIEW is offline   Reply With Quote
Join the #1 RV Forum Today - It's Totally Free!

iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!

You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!

Old 09-17-2017, 11:10 AM   #2
Senior Member
 
Skip426's Avatar


 
Join Date: Apr 2011
Location: Powell River, B.C.
Posts: 24,329
Usually only the one OBD II connector, on any vehicle , within 18" of the steering column on the dash .

Some DP's will have a second diagnostic connector, ( different than a OBD II ) in the engine bay at the rear of the coach , so the mechanic can be at the motor with the read out in hand.
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
Skip426 is offline   Reply With Quote
Old 09-17-2017, 12:44 PM   #3
Member
 
Join Date: Nov 2015
Posts: 48
I have been using an UG on my MBS for the past couple of years. Love it. Gives me a lot more infor vs the basics on my MBS version. Some people do have the better MBS gauge package.Mine does not. The port is just above the release on the lower left. I had to set the fuel ecoomy up on the UG using the direction sthey give. Other than that it works perfectly. I have not had to do any trouble code investigations

regards
MarsMan is offline   Reply With Quote
Old 09-18-2017, 08:57 AM   #4
Junior Member
 
AK VIEW's Avatar
 
Join Date: Sep 2013
Location: ALASKA - Summer / ARIZONA - Winter
Posts: 12
Red face Update

After further detailed investigation I found a OBSII SHORT FLAT EXTENSION CABLE, ( OBD-II 16Pin Male to Female Low Profile Extension Cable Diagnostic Extender 30cm)
http://www.amazon.com/dp/B007PBHF8M/..._M3T1_ST1_dp_1
This should allow the fuse access door to close. Since we're leaving tomorrow for AZ from Fairbanks ordering the parts and scanner will have to wait, darn.
AK VIEW is offline   Reply With Quote
Old 09-25-2017, 02:31 PM   #5
Senior Member
 
Winnebago Owners Club
Join Date: Jul 2017
Location: Plattsburgh, NY
Posts: 207
I just added a Scan Gauge on my Winnebago Era on a 2014 Sprinter van chassis. Mounted the unit under the ignition switch with Velcro and ran the power cord over the steering column under the dash to the OBD port over the fuse box. I simply cut the top of the plastic cover away to accommodate the cord on it's route, closes nicely.
604eholston is offline   Reply With Quote
Reply



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Ultragauge Group Buy? Kxbronco iRV2.com General Discussion 5 04-05-2016 04:25 PM
ScanGauge vrs UltraGauge on F53 chassis Timon Ford Motorhome Chassis Forum 14 10-27-2015 05:57 AM

» Featured Campgrounds

Reviews provided by


All times are GMT -6. The time now is 03:54 PM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, vBulletin Solutions, Inc.