Community Forums

camper8251 · 02-28-2020, 06:02 PM

So working on installing my EMS.. Opened up location where breaker panel is and saw these wires against the back wall..

Any Ideas what they are or were for? Kinda strange...
As far as I know everything works in the TT.

ttavasc · 02-28-2020, 06:30 PM

I went out and pulled the pantry drawers and took a look in my 23DBS. My best guess is they may have been a bad set of wires for the slide controller. See picture below. If you look at the Motor 1 and Motor 2 wire identification printed on the front of my slide controller the number of wires and colors seem to match the cut wires shown in your picture.

camper8251 · 02-28-2020, 06:34 PM

Thanks appreciate the check. Never even thought to look at the slide controller but then again its tucked behind the drawer slide.. Who would have thought that was a good idea???????

keymastr · 02-28-2020, 09:47 PM

Certainly looks that way, Good catch. Either the wires were pinched and they ran a new set or someone put them in the position of a different floor plan.

Tuquala · 02-28-2020, 10:01 PM

You think that's a poor spot for the controller, eh?? In our '16 280RKS (and I'm sure all other 280s) it is in the drivers side front closet, AND you cannot access if the slide is in!!! Maybe a rental child with skinny arms might, but will they understand the writing on the controller??!!!!!