How do you mark attractions in RV Trip Wizard?
I'm using RV Trip Wizard, and I can't figure out how to do this:
Let's say I'm headed to a new city for a week. Ahead of time, I did some research and found 25 things I might want to do around that city. I'd like to be able to put markers down for those 25 locations and have them on my map.
Then when I'm in the city, I can see the 25 things I had previously found. If I'm heading to the southwest part of town, I can see what markers are in that area, and decide what I want to do.
Theoretically, I could add them as actual stops on my RV route, but I have no idea what order I would want to do them during that week, and I'd end up with my route zig-zagging all around in a big mess on the map. Another issue is that I'll be doing all that sightseeing in my tow car, which has no height restrictions. If I treat those attractions like stops on my RV route, it will be sure to keep me away from low bridges, which isn't necessary. Also, as I drive around town, the program is going to start warning me that my RV needs fuel, even though I'm not even driving the RV.
I want to keep my RV route as the route I'll actually be driving my RV from city to city, not including all the little sightseeing trips I do in my tow car while I'm in town.
I contacted RTW, and they said it can't be done in the program. However, I'm sure people somehow keep track of the 25 things they want to do in a city, and where they are located. I'd rather not maintain a separate map for just the attractions, and I don't want to just have a list with addresses. I'd really like to have them on my RTW map.
Any ideas? How do you guys do it?
|