iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Does it operate smoothly to that point and then just stops? Does the motor shut off when the slide stops moving. If this is the case I'd check the slide travel limit switch. There are 2 - one for each direction and they are adjustable. Most likely only accessible through the zippered belly fabric underneath.
Does it operate smoothly to that point and then just stops? Does the motor shut off when the slide stops moving. If this is the case I'd check the slide travel limit switch. There are 2 - one for each direction and they are adjustable. Most likely only accessible through the zippered belly fabric underneath.
Thanks for you help. Sounds like the travel limit switch is the answer. I opened the rear zippered compartment and did not see anything obvious that looked like a plus/minus switch. I did see the square bar that runs/connects to the rear gear. I opened all four zippered compartments and could not find any switch. Perhaps the switches for all three slides are located together? I will keep looking.
I can't recall the exact method, but my RV mechanic showed me a trick about resetting the slide limit switch. You might check with whomever you frequently deal with.
__________________
Sent from my semi-smart phone. Errors likely caused by talk-to-text, auto-correct, or fat fingers.
Mine are visible from inside on my full wall slide. I don't know exactly where they would be on your flush floor slides but most likely somewhat obscured in the framing of the slide mechanism. Good luck.
Limit switch. After another look and help from my wife running the slide in and out - there is a bolt that screws in or out and after adjusting the bolt our slide is working correctly.