Slideout Coax Connection Holiday Rambler 2002

[bbdmac]

Hi,

I have a 2002 Holiday Rambler Presidential 5th Wheel that I need to replace the coax wiring on. The external jack is located on the driver side rear of the unit and then it feeds into the wall and over to the slide out where the entertainment cabinet is located. Does anyone know how they run that cable from the rear of the unit over to the slideout? I've looked quickly underneath but I can't see anything resembling a retractable arm with cables on it that might be where the cable is run over to the moving slideout. Or do I need to remove the panels on the underside of the unit to see anything?

Thanks

bbdmac

[clifford j]

BBDMAC, I have a 2007 37SKQ . There are 2 driver side jacks at the rear just over the power land cable. The rear driver slide has a square box bar on the rear end under the floor next to the slide rack. Inside the box are the power wires and tv cable. Not sure if there is access to replace the cables easily. I would abandon the origional cable and mount a 'new' inlet jack. My tv is wall mounted in the slide on the outer wall. My electronics are in the overhead cabinets. I have a roof DTV dish . I did run a coax from the DTV box forward to my bedroom tv. Was time consuming but not too difficult.
Hope this helps

CLIFFORD

[bbdmac]

Thanks Clifford j, I'll take a look Thursday night when I go back to the park. I'm thinking it's probably best to simply add a jack to the outside of the slide out and just feed it into my "entertainment center".


Bob