Community Forums

Mojo11 · 07-25-2022, 03:59 PM

I have a 2013 ORV Tmiber Ridge with a super slide. Has anyone ever removed the side trim pieces where the bulb seal attaches? Trim is about 4 inches long but only covers the side wall of the slide about an inch. I can see the screws that attach it but my concern is if the trim is glued to the outer wall of the slide.
Had a small leak this year in the corner of my slide roof. Laminated wall is a little bulged along the side. Would like to pull of trim and dry out the Luan and see what I can do to repair. Wall is thick Styrofoam then Luan then fibreglass I believe.

Jay D. · 07-25-2022, 05:36 PM

it should wrap around and the screws should be on the inside. i took my side pieces off and once you get the screws out mine had a lot of sealer packed in there. a sharp putty knife will cut through the sealer. then the big job is getting all of it off the trim piece and the wall part.
Jay D.

Mojo11 · 07-25-2022, 06:28 PM

Yes found all the screws on the inside, was worried there maybe a permanent glue in there. I can deal with just sealant.

Jay D. · 07-26-2022, 11:01 AM

Quote:

Originally Posted by Mojo11

Yes found all the screws on the inside, was worried there maybe a permanent glue in there. I can deal with just sealant.

ha-ha i gust figured out why the picture look funny its vertical insted of horizontal anyway i did the same thing you'll be ok after you remove the screws it should pull off with the help of a putty knife mine had the sticky tape stuff under it. came off relatively easy