Through frame slide
Hi All,
Long story short, slide got stuck and skipped 3+ teeth on motor side. I fixed the getting stuck issue but now need to straighten it out.
Lippert says disengage gear and push slide in to realign. Easy enough but I have a couple of questions.
The picture below is my gear pack.
Do I extend slide half way?
Do I need to lift it some to get weight off gear? If so where do I lift it??
If so, do I let it down when gear is disengaged so I can move the slide?
Do I need to remove the bar the arrow is pointing at or will it loosen when I loosen gear?
NOTE: This is NOT an in wall schwintek!
Thanks!!
|