I replaced my original switching center, because of a broken solder.
Did some research and found that the Magnadyne model:VCS-10
Was the direct replacement for my old Winegard unit.
Installed the VCS-10 per instructions.
After install, unit will NOT switch.
Call Magnadyne tech support went thru all the test with them.
Checking cables, attached antenna directly to TV got picture.
Tech support determined unit is faulty.
Got second unit installed, same problem.
Got in touch with tech support again did test. Again determined unit is bad.
Got unit number three same result.
Unable to reach tech support by phone or email.
Very frustrating at this point. Hoping someone here have an idea of what
To check or if anyone have installed one of these units.
Or if I have to replace it, with what.
Thanks in advance
Linear Mode
