A/C Swap help
Hello, first off thanks for reading. So I have a Coleman Mach 3 AC unit that is shot. I had a service tech out, replaced the fan etc. I decided to upgrade to a Dometic Brisk Air II. Install seemed to go fine until wiring…
No new control panel in the box or any installation instructions. The old wiring harness is a 9 hole female receptor, whereas the new one is a 6 hole receptor.
Is there a part adapter for this, or do I need to change the harness and thermostat all together? I know little to nothing about AC units or wiring. I know I have a ducted and 1 zone thermostat. It also controls heat as well. I was assured by camping world it was plug and play. Any help
would be appreciated. I’m a full timer due to circumstances and Florida gets hot. Thanks
|