Hello. Not sure where to go to start a post. I'm beside myself with this New Brisk II that I purchased. I can't get it to run, and thermostat is throwing an E1 error code. Not sure if wiring at control box is correct.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
It's was the original 1991 Penguin..wasn't holding a charge. I opted to install a new unit. Dometic Brisk II. The control kit box is not communicating with the thermostat. Throwing E1 error codes. I reset the thermostat. Everyone seems to think it's the control box. They tested a/c by jump starting it and it works. I am in a very remote place and there seems to be no authorized service around. I'm going to salt lake tomorrow to pick up another box. Pretty sure it's wired correctly