Originally Posted by kqs-curtice
We have a 2002 Monoco Windsor with the HWH Air Leveling system(no jacks). It levels fine however, we cannot get into travel mode. We've checked the 3 wire plug and found 2 of the wires had current. The middle wire (ignition wire per HWH) no current. Also checked the fuse on the control panel. Would anyone know of anything else we could check. Or of anyone in the Austin area that may have knowledge of this system.
Try this sequence.
1. Turn on the HWH levelers.
2. Dump the air until the suspension is all the way down. Make sure you won't damage your steps or rear mud flap or lower onto some obstruction.
3. Turn off the HWH keypad.
4. Crank the engine & run at high idle.
5. Go out side & watch the suspension air up. It may take a few minutes if the air system was low. By the time the air governor purges the dryer it should be up.
The suspension should return to ride height. The green light may not turn on until you put the transmission in gear.