Community Forums

daveinaz58 · 03-18-2025, 04:32 PM

I was working on our 2004 Winnebago today and I noticed that the large living room slide is not coming in quite like it should. I noticed that the (as you're looking at it from the outside) that the bottom left corner is out about 3/8-1/2 and inch and the upper right corner is out about the same distance. The upper left and lower right are flush.

azpete · 03-19-2025, 10:24 AM

what mechanism is it mounted on. x arm, or under the floor. if its under the floor, its only attached at the bottom. that would not cause the room to warp.

DT4452 · 03-19-2025, 11:51 AM

Sounds like you need to synchronize the cylinders, hold the button down for a few seconds after the slide reaches the end of its travel in and out a few times and that should do it.

daveinaz58 · 03-19-2025, 07:09 PM

Quote:

Originally Posted by DT4452

Sounds like you need to synchronize the cylinders, hold the button down for a few seconds after the slide reaches the end of its travel in and out a few times and that should do it.

thanks. I'll give that a try.

daveinaz58 · 04-19-2025, 07:28 PM

Quote:

Originally Posted by DT4452

Sounds like you need to synchronize the cylinders, hold the button down for a few seconds after the slide reaches the end of its travel in and out a few times and that should do it.

Yep, that was it. thanks.