HWH Leveling System

[Afubar]

On my 96 Mountain Aire the HWH Leveling System appears to have a leak. On the picture below, the most appears to be at the second from the bottom bolt and at the top of the U shape where it bolts in.

My question is are there rubber washers there that can be replaced or can those bolts (?) Be tightened down.

System is the HWH 310.

Any suggestions or ideas welcomed.

Thanks
Kaye

[RV735]

Afubar, If I understand you, I would take a wrench and snug all the connections on the U shape piping. The four bolts hold the manifold pieces together. They also can be snugged down (don't torque). Look at the top of your picture where the U shape that screws in to the copper colored fitting: that copper fitting is the shuttle valve.

Good Luck!

I had to replace the entire hydraulic pump, motor and tank assembly when the pump failed this past summer.

Safe travels and THE JOY IS IN THE RIDE

[Afubar]

Thanks RV735, I hoped that attempting to tighten them up wouldn't cause more problems. The jacks, pump, and all work fine, it just slowly leaks on top and I have to top off the reservoir every few months.

Thanks again